Porsche 944 power Steering fluid

You should eliminate the pump from under. Utilizing the vehicle properly raised and supported take away the underneath engine tray (purple arrow). Please see our article on under tray elimination for extra assistance.

Figure 4

Regarding power steering pump start by loosening the 13mm bolt at the top associated with energy steering mount (red arrow, concealed behind the pulley). After that ensure that the turnbuckle is neat and free of oil and oil (yellow arrow).

Figure 5

Use two 13mm wrenches and split the dual peanuts for each end for the turnbuckle (red and yellow arrows).

Figure 6

Because of the peanuts free utilize the 13mm wrench and turn the turnbuckle such that it loosens stress in the buckle (red arrow).

Figure 7

Utilize a 13mm wrench or plug and take away the mounting bolt in the pump (purple arrow).

Figure 8

Utilizing the turnbuckle free you are able to go the pump to the center associated with engine (purple arrow) and take away the buckle.

Figure 9

There are two main outlines connected to the pump, the supply range from reservoir (yellow arrow) while the force line (red arrow). Usually do not get rid of the lines now, but do break loose the banjo installing on the stress range with a 19mm wrench (red arrow). its easier to loosen this range although the pump remains attached but better to clear the range and catch the fluid once the pump is down.

Figure 10

Use a 13mm wrench and take away the nut regarding front side of the pump (purple arrow). Following, make use of a 13mm wrench and remove the 13mm bolt in the rear. Slide the bolt through the rear and slip the pump-back and forth and soon you can take away the sleeve while the stud clears the mount.

Figure 11

With the pump off you can view the sleeves your front stud and rear bolt sit in in the mount (red arrows). Aided by the pump off its much easier to get rid of the banjo suitable (yellow arrow) and invite the line to drain into a bucket. After that use a flathead screwdriver and remove the supply range (green arrow) and permit it to empty as well. Installation could be the reverse of removal. It is best if you fill the system and then switch the pump repeatedly by hand to simply help evacuate the air from system before installing the buckle. The machine cannot perform well with atmosphere within the system so that you will have to operate it, include liquid as necessary and permit the foam or environment into the system to be in. Do that many times unless you have the proper degree of fluid.