Porsche 997 rear spoiler

Look inside the motor compartment in the right-side. It is additionally vital to locate the wiring use from stock decklid down seriously to the connector as shown here. Push the loss on the connector (green arrow) to release the the main use linking on stock decklid. If you are going from a stock deck cover with a movable wing to a hard and fast wing, the best way to prevent the wing caution light from coming-on is to replace the wiring harness with a set wing use available from Pelican components.

Figure 2

Very first, firmly offer the deck top in the great outdoors place. Unless you have a friend assisting you with this particular an element of the task, be sure you utilize a thing that will hold the wing up and set up when you are focusing on it. eliminate the plastic cover on decklid shock that holds the wiring use (green arrow).

Figure 3

After that, pry the upper decklid surprise link off (green arrow).

Figure 4

Now loosen and take away the four 10mm bolts keeping the hinges into rear decklid (green arrows). Note, right side shown. Kept side is identical. When unbolted, have someone help you get rid of the stock decklid.

Figure 5

Have some body help you line the newest rear wing and decklid with the depends on the car. Once lined up precisely, thread the 10mm bolts back in and tighten all of them down snug but not right. You may have to make a few changes to obtain the brand-new deck top to fit properly. You can see in thePicture that there surely is a fair amount of room for changes. Be sure you connect the plastic address holding the wiring use to the decklid shock.

Figure 6

Don't forget to plug the latest wiring harness from new rear wing (purple arrow) into the connector in the engine bay (green arrow).